Exabyte 1X7 LTO 122, Power Specifications, Requirements for International 220 VAC Power Cord

APPENDIX A—SPECIFICATIONS

POWER SPECIFICATIONS

This sections describes the following power specifications for the autoloader:

AC input voltages and power consumption

Power cord specifications

AC INPUT VOLTAGES AND POWER CONSUMPTION

The autoloader includes an internal power supply that is capable of accepting 100 to 240 VAC at 50 or 60 Hz. The autoloader has automatic AC input voltage selection. The autoloader is capable of continuous operation when the AC power experiences intermittent operation, voltage surges, and voltage spikes. The maximum operating power consumption for the autoloader is

70 Watts RMS.

POWER CORD SPECIFICATIONS

The autoloader is shipped with two power cords: One for use in the US and Canada, and one for use in Europe.

The US/Canada power cord is a 2.3-meter (7.5-foot), three-conductor, 18 AWG power cord for 120-volt use. The power cord has a molded NEMA 5-15P male connector on one end and a molded IEC 320/EN60320 female connector on the other end. The power cord is UL Listed and CSA Certified.

The European power cord is a 2.5-meter (8.2-foot) power cord for 230 to

250-volt use. The power cord has a CEE 7 Standard VII, dual earthing male connector on one end, and an IEC 320 C13 female connector on the other end. The cordage is CENELEC HD-21. The power cord is VDE approved.

Requirements for International 220 VAC Power Cord

If you plan to use the autoloader in a location other than the US/Canada or Europe, you must supply a power cord that meets the following specifications:

The power cord must have a grounded attachment plug of the proper type, rating, and safety approval for the intended country.

The power cord must have an IEC 320/EN60320 female connector on one end.

The cordage must be harmonized to CENELEC publication HD-21. The electrical characteristics and rating must be minimum H05VVF3G1.00 (10 A).

122

PRODUCT MANUAL 1012581