Exabyte 1X7 LTO manual Performing Diagnostic Tests

PERFORMING DIAGNOSTIC TESTS

PERFORMING DIAGNOSTIC TESTS

To check basic autoloader functions, you can run a set of diagnostic tests from the operator panel. These tests check the autoloader’s internal memory, voltages, and SCSI functions. If you report a problem to Exabyte Technical Support, you may be asked to run these tests and provide the results.

To run the autoloader’s diagnostic tests:

1.At the Home screen, press , , , or to access the main menus. If necessary, enter the operator panel password (see page 42).

2.Press or until the Diagnostic menu appears:

P e r f o r m a

D i a g n o s t i c

3.Press to see the menu selections, then press or until the following screen appears:

			R	u n	h	a r d w a r e
			s	e l	f t	e	s t	?
4.	Press	. A confirmation message appears:
			S	t a r t			h a r d w a r e
			s	e l f t e s t				n o w ?
5.	Press	to start the test (or					to cancel the test).

The test begins. When the test is finished, the following screen appears:

H / W s e l f t e s t

p a s s e d .

6.Press (as needed) to return to the Home screen.

OCTOBER 2006 MAGNUM 1X7 LTO AUTOLOADER

77