Exabyte 1X7 LTO manual Attaching the Autoloader to the Rails, 6Placing the autoloader on the rails

CHAPTER 2—INSTALLING THE AUTOLOADER

Insert an M5 screw (A) through a second screw hole (B) and engage the pem nut on the second screw hole in the rail flange (C). If necessary, use a washer. Finger-tighten the screw.

3.Adjust the length of the rail assembly as necessary to fit the depth of the rack (E).

4.Back of rack—Make sure the rail assembly is level, then use M5 screws (A) to attach the back flange (D) of the rail to the inside of the rack, using the same procedure as step 2. If your rack has square mounting holes or the holes are much larger than the screws provided in the kit, use a washer. Finger-tighten the screws.

5.Using a #2 Phillips screwdriver, tighten the screws securing the rails to the front and back of the rack.

6.Using a #2 Phillips screwdriver, tighten the four screws holding the rail assembly together.

7.Right side rail assembly—Repeat steps 1 through 6 for the right-side rail assembly. Make sure that the right rail assembly is at the same level as the left rail assembly.

ATTACHING THE AUTOLOADER TO THE RAILS

To attach the autoloader to the rails:

1.From the front of the rack, place the autoloader onto the shelf created by the rails (see Figure 2-6).

Figure 2-6Placing the autoloader on the rails

2.Slide the autoloader all the way back until it makes contact with the small flanges near the back of the rails (see Figure 2-7).

14

PRODUCT MANUAL 1012581