Exabyte 1X7 LTO manual 137, Error Message Description Corrective Action Servo Timeout

		TAPE ALERT FLAGS
Table C-1Autoloader error messages (continued)
Error Message	Description	Corrective Action
Servo Timeout	The autoloader carousel has	1. Reset the autoloader and retry the
	experienced a problem.	operation.See page 74 for reset
		instructions.
		2. If the error persists, contact Exabyte
		Technical Support (see page iii) or your
		service provider.
System Error	The autoloader has experienced a	1. Reset the autoloader and retry the
	fatal error.	operation.See page 74 for reset
		instructions.
		2. If the error persists, contact Exabyte
		Technical Support (see page iii) or your
		service provider.
System Timeout	An autoloader operation took too	1. Reset the autoloader and retry the
	long.	operation.See page 74 for reset
		instructions.
		2. If the error persists, contact Exabyte
		Technical Support (see page iii) or your
		service provider.
Tape Alert Halt	The autoloader has experienced a	1. Reset the autoloader and retry the
	Tape Alert event.	operation.See page 74 for reset
		instructions.
		2. If the error persists, contact Exabyte
		Technical Support (see page iii) or your
		service provider.
Tape incorrectly	A tape was inserted through the	Position the cartridge with the hub down
inserted. RETRY	cartridge access port in the wrong	and the side with the bar code label and
	orientation.	write-protect switch towards the door (see
		page 65) and re-insert it. Do not insert
		cartridges with the label and write-protect
		switch toward you. The arrow on the
		cartridge must face toward the outside.
Wait for Command	The autoloader is executing a	Wait until the autoloader has finished its
To Complete	command issued from the	current operation, then retry the operation.
	application or the Remote
	Management utility when a
	command is issued from the
	operator panel.

OCTOBER 2006 MAGNUM 1X7 LTO AUTOLOADER

137