Exabyte 1X7 LTO manual 136

APPENDIX C—ERROR MESSAGES

Table C-1Autoloader error messages (continued)

Error Message	Description	Corrective Action
In Enet Mode	The autoloader is executing a	Wait until the autoloader has finished its
	command issued from the Remote	current operation, then retry the operation.
	Management utility (see Chapter 4)
	when a command is issued from the
	operator panel.
In Security Mode	Autoloader security has been set	Disable autoloader security from the
Choice Rejected	from the application.	application.
Library is BUSY	The autoloader is executing a	Wait until the autoloader has finished its
	command issued from the	current operation, then retry the requested
	application when a command is	operation.
	issued from the operator panel.
Media Removal	Media removal from the autoloader	Turn off media removal prevention from
is Locked by Host	has been prevented through the	the application and retry the operation.
	application.
Over Temperature	The tape drive’s temperature limit	ƒ	Wait until the autoloader has cooled,
	has been exceeded, and the		then unload the cartridge to a cell and
	cartridge has been ejected from the		re-load it into the tape drive.
	drive.	ƒ	Check the room temperature. The
			ambient temperature must be no more
			than 40°C (104°F).
		ƒ	Provide additional air flow around the
			autoloader to improve cooling.
POST Failed	The autoloader encountered an	1. Reset the autoloader and retry the
	error during its power-on self-test.		operation.See page 74 for reset
			instructions.
		2. If the error persists, contact Exabyte
			Technical Support (see page iii) or your
			service provider.
Sequential Mode	An application tried to issue	Set the autoloader to Random mode (see
	commands to the autoloader while	page 38).
	it was in Sequential mode.
Servo Error	The autoloader carousel has	1. Reset the autoloader and retry the
	experienced a problem.		operation.See page 74 for reset
			instructions.
		2. If the error persists, contact Exabyte
			Technical Support (see page iii) or your
			service provider.
Servo Jammed	The autoloader carousel has	1. Reset the autoloader and retry the
	experienced a problem.		operation.See page 74 for reset
			instructions.
		2. If the error persists, contact Exabyte
			Technical Support (see page iii) or your
			service provider.

136

PRODUCT MANUAL 1012581