Exabyte 1X7 LTO manual Autoloader Scsi ID, Changing the Scsi IDS

SETTING CONFIGURATION OPTIONS

5.Press to display the contrast selection screen:

S	e	l e c t		C o n t r a s t
N	o	w :	n	n

6.	Press	or		to scroll through the available values until the one you want
	appears. The contrast changes as you press the button.
7.	Press	to select the new value. A confirmation message appears:
			S	e t	c o n t r a s t		t o
			n	n	n o w	?
8.	Press	to enact the change (or				if you don’t want to make the change).
9.	Press	(as needed) to return to the Home screen.

CHANGING THE SCSI IDS

Each device on a SCSI bus must have a unique SCSI ID so that it can be identified by the host computer. The autoloader and the enclosed tape drive use separate IDs on the same SCSI bus so that they can receive different sets of commands. You can use the default IDs or change them if they conflict with other devices on the SCSI bus.

Note: If you change the autoloader or tape drive’s SCSI ID after the autoloader has been in operation, you may need to reboot your host computer so that it recognizes the new ID.

Autoloader SCSI ID

To change the autoloader’s SCSI ID:

1.At the Home screen, press , , , or to access the main menus. If necessary, enter the operator panel password (see page 42).

2.Press or until the Configuration menu appears:

C	h	a	n g e	a
C	o	n	f i g	u r a t i o n

3.Press to see the menu selections.

OCTOBER 2006 MAGNUM 1X7 LTO AUTOLOADER

29