Exabyte 1X7 LTO manual Change Ethernet Configuration, Dhcp

CHAPTER 4—USING THE REMOTE MANAGEMENT UTILITY

Field	Description
Emulation	If your autoloader software has not yet been certified for
Mode	the Magnum 1x7 LTO Autoloader, you can set the
	autoloader to emulate the VXA AutoPak 1x10 autoloader,
	EZ17 autoloader, or EXB-210 library. Because most backup
	applications are certified for these libraries, changing the
	emulation mode may allow these applications to support
	the autoloader. See page 31 for more information about
	emulation modes.
Language	The default language for the autoloader’s LCD is English.
	You can change the language to French, German, Italian,
	Portuguese, or Spanish.
Change Fixed	The Autoclean option enables the autoloader to
Cleaning Cell,	automatically perform tape drive cleaning without operator
Auto Clean On,	intervention. See page 32 for information about the
Cleanings	Autoclean option. If you set the Autoclean option on, you
Remaining	must install a cleaning cartridge in cell seven of the
	autoloader and enable the fixed cleaning cell (see page 32).

CHANGE ETHERNET CONFIGURATION

In the Change Ethernet Configuration section, you can specify the autoloader’s IP address, subnet mask, and gateway address. You can also view and change the autoloader’s SNMP settings, including the read, write, and broadcast passwords, trap address, and trap port. See page 35 for information about the autoloader’s Ethernet addresses and SNMP settings.

The autoloader also includes an FTP interface that you can use to transfer firmware files or create diagnostic listings. You can view the autoloader’s default FTP user name and password and change them if desired. For information about accessing the autoloader’s FTP interface and using an FTP utility to upgrade firmware or obtain diagnostic listings, see page 100.

In the Change Ethernet Configuration section, you can change the following settings:

Field	Description
IP Address,	If you are using static addressing (DHCP off), specify the
Subnet Mask,	values for these addresses. If you are using dynamic
Gateway	addressing, specify 0 for these addresses.
DHCP	If you are using dynamic addressing (DHCP on), this field
Assigned	indicates the IP address.
Address	Note: If the DHCP address changes during your session,
	you will need to check the new address on the
	autoloader’s LCD (see page 79) and re-direct your
	browser to the new address.

56

PRODUCT MANUAL 1012581