Zebra Technologies Z6Mplus manual Overview, Enter Configuration Mode

Configuration

Overview

Overview

After you have installed the media and ribbon and the Power-On Self Test (POST) is complete (see Power-On Self Test on page 95 for more information), the front panel displays PRINTER READY. Use the front panel display and the four keys directly below it to set printer parameters for your application.

Note • Printers that are operating on an IP network can be quickly configured in the following ways:

•with the ZebraLink™ WebView (ZebraNet® PrintServer II required). For information, see the ZebraNet Networking: PrintServer II Installation and User Guide.

•with the SetWLAN configuration utility (ZebraNet Wireless Print Server required). For information, see the ZebraNet Wireless Print Server User Guide.

Enter Configuration Mode

To enter configuration mode, complete these steps:

1.From the front panel, press SETUP/EXIT:

2.Press PLUS (+) or MINUS (–) to scroll to the setting you wish to change.

3.Press SELECT to toggle the functionality of PLUS (+) and MINUS (–) keys.

4.Press PLUS (+) or MINUS (–) to increase or decrease the value, answer yes or no, print a label, or select the digit you wish to change.

Note • An asterisk (*) in the upper left-hand corner of the display indicates that the value displayed is different than the currently stored value.

5.Press SELECT again to use PLUS (+) and MINUS (–) to scroll to the desired menu item.

50 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004