Printer Operation
Load Roll Media
7.Feed the media under the dancer, through the slot in the transmissive sensor, under the ribbon sensor, and through the Peel Assembly.
8.Pull approximately 12 in. (30 mm) of media through the front of the printer.
9.Ensure the media is against the rear of the transmissive sensor. Slide in the media guide until it just touches, but does not restrict, the edge of the media.
10.Pull down the peel lever to open the peel assembly.
11.Feed the liner over the
12.Close the printhead assembly.
13.Close the peel assembly using the peel lever.
14.The printer is paused (the Pause light is on), press PAUSE to enable printing. Peeling starts automatically. Press FEED to test.
13163L Rev. 3 5/20/2004 | Z4Mplus/Z6Mplus User Guide | 29 |