Zebra Technologies Z6Mplus manual Load Roll Media, Tear-Off Mode

Printer Operation

Load Roll Media

Load Roll Media

Tear-Off Mode

Tear-Off Mode is the default mode. The printer is set to this mode in the factory. The option is shown in Figure 15.

Figure 15 • Tear-Off Mode

23

1

8 7 6 5 4

1Printhead Assembly

2Transmissive Sensor

3Label Supply Guide

4Label Supply Hanger

5Dancer

6Label Guide

7Printhead Open Lever

8Printed Label

To load media in Tear-Off Mode, complete these steps:

1.Press the printhead open lever. The printhead assembly springs up.

Caution • Ensure that the printhead is fully open and engaged in the upright position. If you fail to latch the printhead, it could fall on your hand during the procedure.

2.Flip down the media supply guide.

3.Slide out the media guide as far from the printer frame as possible.

4.Place the roll of media on the media supply hanger and orient the media properly.

5.Flip up the media supply guide.

6.Slide in the media supply guide until it touches, but does not restrict, the edge of the roll.

7.Feed the media under the dancer, through the slot in the transmissive sensor, under the ribbon sensor, and out the front of the printer.

13163L Rev. 3 5/20/2004 Z4Mplus/Z6Mplus User Guide 25