Zebra Technologies Z6Mplus manual Printer Parameters and Other LCD Displays Sheet 2

Configuration

Configuration and Calibration LCD Displays

Table 9 • Printer Parameters and Other LCD Displays (Sheet 2 of 15)

Parameter		Action/Explanation
TEAR	OFF	Adjusting the Tear-Off Position
		This parameter establishes the position of the media over the tear-off/peel-off bar after
		printing. The label and liner can be torn off or cut between labels.
		Default: +0
		Range: –120 to +120
		1.	Press SELECT to select the parameter.
		2.	Press PLUS (+) to increase the value. Each press adjusts the tear-off position by
			four dot rows.
		3.	Press MINUS (–) to decrease the value.
		4.	Press SELECT to accept any changes and deselect the parameter.
PRINT	MODE	Selecting Print Mode
		Print mode settings tell the printer the method of media delivery that you wish to use.
		Be sure to select a print mode that your hardware configuration supports as some
		selections displayed are for optional printer features.
		Default: Tear-off
		Selections: Tear-off, cutter, peel-off, rewind
		1.	Press SELECT to select the parameter.
		2.	Press PLUS (+) or MINUS (–) to display other choices.
		3.	Press SELECT to accept any changes and deselect the parameter.
MEDIA	TYPE	Setting Media Type
		This parameter tells the printer the type of media you are using. Selecting continuous
		media requires that you include a label length instruction in your label format
		(^LLxxxx if you are using ZPL or ZPL II).
		When non-continuous media is selected, the printer feeds media to calculate label
		length (the distance between two detections of the inter-label gap, webbing, or
		alignment notch or hole).
		Default: Non-Continuous
		Selections: Non-Continuous, Continuous
		1.	Press SELECT to select the parameter.
		2.	Press PLUS (+) or MINUS (–) to display other choices.
		3.	Press SELECT to accept any changes and deselect the parameter.
SENSOR TYPE		Setting the Sensor Type
		This parameter tells the printer whether you are using media with a web (gap or space
		between labels, notch, or hole) to indicate the separation between labels or if you are
		using media with a black mark printed on the back. If your media does not have black
		marks on the back, leave your printer at the default setting (web).
		Default: Web
		Selections: Web, mark
		1.	Press SELECT to select the parameter.
		2.	Press PLUS (+) or MINUS (–) to display other choices.
		3.	Press SELECT to accept any changes and deselect the parameter.

58 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004