Zebra Technologies Z6Mplus manual Liner Take-Up Mode

Printer Operation

Load Roll Media

Liner Take-Up Mode

The Liner Take-up option must be installed to use this mode. The option is shown in Figure 18.

Note • This option is available on the Z4Mplus printer only

Figure 18 • Liner Take-Up Mode

	2	3
12
	1
11
		6
10		7	4
9		5
8

1Printhead Assembly

2Transmissive Sensor

3Label Supply Guide

4Label Supply Hanger

5Liner Take-Up

6Dancer

7Label Guide

8Printhead Open Lever

9Peel Assembly

10Label

11Peel Lever

12Tear-Off/Peel-Off Bar

To load media in Liner Take-Up Mode, complete these steps:

1.Press the printhead open lever. The printhead assembly springs up.

Caution • Ensure that the printhead is fully open and engaged in the upright position. If you fail to latch the printhead, it could fall on your hand during the procedure.

2.Flip down the media supply guide.

3.Slide the media guide as far from the maim frame as possible.

4.Place a roll of media onto the media supply hanger as shown.

30 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004