Zebra Technologies Z6Mplus manual If the ribbon Then

Printer Setup

Ribbon

5.Observe the results. Did the ribbon leave a mark on the paper?

If the ribbon...	Then...
Left a mark on the paper	The ribbon is coated on the outer surface.
Did not leave a mark on	The ribbon is likely coated on the inner surface.
the paper	a.	Flip the ribbon over on the paper so the inner side of the
		ribbon comes in contact with the paper.
	b.	Scratch the outer surface of the unrolled ribbon with
		your fingernail.
	c.	Lift the ribbon from the paper.
	d.	Observe the results again. The ribbon should have left a
		mark on the paper. If not, repeat the test, starting with

the first side again. You may need to scratch the surface of the ribbon harder.

13163L Rev. 3 5/20/2004 Z4Mplus/Z6Mplus User Guide 19