Zebra Technologies Z6Mplus manual Install Memory Card

Printer Operation

Install Memory Card

Install Memory Card

The printer can use Type I or Type II compliant PCMCIA memory cards.

Electrostatic Discharge Caution • Observe proper electrostatic safety precautions when handling any static-sensitive components such as circuit boards and printheads.

Note • The PCMCIA card is hot-swappable. It can be installed while the printer is On (l).

To install the PCMCIA memory card, complete these steps:

1.Remove the PCMCIA card shield from the rear of the printer.

2.Insert the PCMCIA card, with the notch UP, into the card slot as shown (see Figure 31). Insert the card far enough to cause the eject button to pop out.

Figure 31 • Installing the PCMCIA Card

Notch

Card Eject

Button

PCMCIA

Card

3.Reinstall the PCMCIA card shield over the PCMCIA card and card slot.

The printer is now ready to operate with the additional memory or font option.

Note • Initialization of the PCMCIA card may take a few minutes; the PAUSE LED flashes while the card initializes. If the card is already initialized, the PAUSE LED flashes only once or twice. To verify that the card has successfully initialized, print a configuration label and review it to see if the new memory card information is listed.

48 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004