Zebra Technologies Z6Mplus manual List ALL, Format Card

Configuration

Configuration and Calibration LCD Displays

Table 9 • Printer Parameters and Other LCD Displays (Sheet 5 of 15)

Parameter		Action/Explanation
LIST	NETWORK	List Network Settings
		This selection is used to print a network configuration label, which lists the settings for
		the wired ZebraNet PrintServer II (PSII) and the ZebraNet Wireless Print Server (if
		installed). (Same label as Figure 29 on page 45.)
		1.	Press SELECT to select the parameter.
		2.	Press PLUS (+) to print a network configuration label.
		3.	Press SELECT to deselect the parameter.
LIST	ALL	List All Settings
		1.	Press SELECT to select the parameter.
		2.	Press PLUS (+) to print a label listing all of the available fonts, bar codes, images,
			formats, the current printer configuration, and the current network settings.
		3.	Press SELECT to deselect the parameter.

FORMAT	CARD	Initialize Memory Card
A	B	Caution • Perform this operation only when it is necessary to erase all previously
		stored information from the optional memory card.

1.Press SELECT to select the parameter.

If your printer is set to require a password, you are prompted to enter the password.

2.Enter the password, then press SELECT.

3.Press the PLUS (+) to select B memory (PCMCIA card) or press MINUS (–) to select the A memory (internal compact flash).

The front panel LCD asks ARE YOU SURE? .

4.Press MINUS (–) to select No and cancel the request.

The INITIALIZE CARD prompt is displayed.

OR

Press PLUS (+) to select YES and begin initialization.

FORMATTING CARD displays. Depending on the amount of memory in the memory card, initialization may take up to three minutes to complete. When formatting is complete, FORMAT CARD displays.

5.Press SELECT to continue with the next prompt.

13163L Rev. 3 5/20/2004 Z4Mplus/Z6Mplus User Guide 61