Zebra Technologies Z6Mplus WEB S Media S Ribbon S . Take Label Media LED Ribbon LED, Idle Display

Configuration

Configuration and Calibration LCD Displays

Table 9 • Printer Parameters and Other LCD Displays (Sheet 14 of 15)

Parameter Action/Explanation

WEB S .

MEDIA S .

RIBBON S . TAKE LABEL MEDIA LED RIBBON LED

These parameters are automatically set during the calibration procedure. They should be changed only by a qualified service technician. See the Maintenance Manual for more information on these parameters.

Press PLUS (+) repeatedly to skip these parameters.

LCD ADJUST LCD Display Adjustment

This parameter allows you to adjust the brightness of your display if your display is difficult to read.

Range: 0 to 19

1.Press SELECT to select the parameter.

2.Press MINUS (–) to decrease the value (reduce brightness).

3.Press PLUS (+) to increase the value (increase brightness).

4.Press SELECT to accept any changes and deselect the parameter.

FORMAT CONVERT

Format Convert

The Format Convert setting is used when upgrading from a printer of lower resolution to a printer of higher resolution and the user does not wish to modify their formats.

Example: If your original formats were written for a 150 dpi printer and your new printer is 300 dpi, you would choose 150–>300.

Default: None

Selections: None, 150–>300, 150–>600, 200–>600, 300–>600

1. Press SELECT to select the parameter.

2. Press PLUS (+) or MINUS (–) to display other choices.

3. Press SELECT to accept any changes and deselect the parameter.

IDLE	DISPLAY	Idle Display
		If a real-time clock (RTC) is installed, this parameter selects the LCD options for the
		RTC.
		Default: FW Version
		Selections: FW Version, MM/DD/YY 24HR, MM/DD/YY 12HR, DD/MM/YY 24HR,
		DD/MM/YY 12HR
		1.	Press SELECT to select the parameter.
		2.	Press PLUS (+) or MINUS (–) to display other choices.
		3.	Press SELECT to accept any changes and deselect the parameter.
RTC	DATE	RTC Date
		If the RTC is installed, this parameter allows changing of the date.
		1.	Press SELECT to select the parameter.
		2.	Press PLUS (+) to increase the value of the selected digit.
		3.	Press MINUS (–) to move to the next digit.
		4.	Press SELECT to accept any changes and deselect the parameter.

70 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004