Printer Operation

Load Roll Media

5.Flip up the media supply guide.

6.Slide in the media supply guide until it just touches, but does not restrict, the edge of the media.

7.Feed the media under the dancer, through the slot in the transmissive sensor, and under the ribbon sensor.

8.Pull approximately 18 in. (500 mm) of media through the front of the printer.

9.Remove the labels from the exposed media until only liner remains.

10.Ensure that the media is against the back of the transmissive sensor. Slide in the media guide until it just touches, but does not restrict, the edge of the media.

11.Pull down the peel lever to open the peel assembly.

12.Feed the media over the tear-off/peel-off bar and behind the peel assembly.

13.Close the printhead assembly.

14.Close the peel assembly.

15.Slide the liner into the slot (see Figure 19) in the spindle of the liner take-up. Ensure that the liner is resting against the back plate of the spindle assembly.

Figure 19 • Liner Take-Up Spindle

Slot

16.Turn the spindle assembly counterclockwise a few times to snug the liner.

17.If the printer is paused (the pause light is on), press PAUSE to enable printing. Peeling starts automatically. Press FEED to test.

13163L Rev. 3 5/20/2004

Z4Mplus/Z6Mplus User Guide

31

Page 49
Image 49
Zebra Technologies Z6Mplus manual Liner Take-Up Spindle