Zebra Technologies Z6Mplus manual ZebraNet Wired and Wireless Print Server LCD Displays

Configuration

Configuration and Calibration LCD Displays

ZebraNet® Wired and Wireless Print Server LCD Displays

The menu options shown in Table 10 display only if you have the ZebraNet PrintServer II, 10/100 PrintServer, or Wireless Print Server installed.

		Table 10 • Print Server LCD Displays
LCD		Explanation
IP	PROTOCOL 1	IP Protocol
		Allows either the user (permanent) or the server (dynamic) to select the IP address.
		If a dynamic option is chosen, this selection determines the method(s) by which the
		print server (wired or wireless) receives the IP address from the server.
		• Press the right or left oval to display other choices.
		Default: ALL
		Selections: ALL, GLEANING ONLY, RARP, BOOTP, DHCP, DHCP AND BOOTP,
		PERMANENT
		Note • Use of GLEANING ONLY is not recommended when the Wireless Print
		Server is installed.
IP	ADDRESS 1	IP Address
		This parameter allows you to select the IP address if PERMANENT was chosen in
		IP PROTOCOL. (If a dynamic option was chosen, the user cannot select the address.)
		1. Press the left oval to move to the next digit position.
		2. Press the right oval to increase the value of the digit.
SUBNET MASK 1		Subnet Mask
		This parameter selects the part of the IP address that is considered to be part of the
		local network. It can be reached without going through the default gateway.
		1. Press the left oval to move to the next digit position.
		2. Press the right oval to increase the value of the digit.
DEFAULT		Default Gateway
GATEWAY 1		This parameter allows you to select the IP address that the network traffic is routed
		through if the destination address is not part of the local network.
		1. Press the left oval to move to the next digit position.
		2. Press the right oval to increase the value of the digit.
MAC ADDRESS 2,3		MAC Address
		This parameter cannot be changed through the front panel.
ESSID 2,3		ESSID
		This parameter cannot be changed through the front panel.

1These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to address 192.168.254.254.

2Appears only when the ZebraNet Wireless Print Server is installed.

3If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.

4This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the card supports LEAP.

72 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004