Zebra Technologies Z6Mplus manual To load media in Peel-Off Mode, complete these steps

Printer Operation

Load Roll Media

Peel-Off Mode

This setting works only with the Peel-Off Option installed on the printer. Figure 17 shows the printer with the Peel-Off Option.

Figure 17 • Peel-Off Mode

11

3

2

101

1

9			5
	7	6	4
8

1Printhead Assembly

2Transmissive Sensor

3Media Supply Guide

4Media Supply Hanger

5Dancer

6Media Guide

7Printhead Open Lever

8Peel Assembly

9Label

10Peel Lever

11Tear-Off/Peel/Off Bar

To load media in Peel-Off Mode, complete these steps:

1.Press the printhead open lever. The printhead assembly springs up.

Caution • Ensure that the printhead is fully open and engaged in the upright position. If you fail to latch the printhead, it could fall on your hand during the procedure.

2.Flip down the media supply guide.

3.Slide the media guide as far from the printer main frame as possible.

4.Place a roll of media onto the media supply hanger as shown.

5.Flip up the media supply guide.

6.Slide in the media supply guide until it just touches, but does not restrict, the edge of the media.

28 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004