Zebra Technologies Z6Mplus manual Printer Operation

Printer Operation

Load Roll Media

6.Slide in the media supply guide until it touches, but does not restrict, the edge of the roll.

7.Feed the media under the dancer, through the slot in the transmissive sensor, under the ribbon sensor, and through the cutter module.

Caution • The cutter blade is sharp. Do not touch or rub the blade with your fingers.

8.Ensure that the media is against the back of the transmissive sensor. Then, slide in the media guide until it touches, but does not restrict, the edge of the media.

9.Close the printhead assembly.

10.If the printer is paused (the Pause light is on), press PAUSE to enable printing.

13163L Rev. 3 5/20/2004 Z4Mplus/Z6Mplus User Guide 27