Zebra Technologies Z6Mplus manual To adjust the reflective sensor, complete these steps

Routine Care and Adjustments

Position the Label Sensor

To adjust the reflective sensor, complete these steps:

1.See Figure 38. Open the printhead assembly by pressing the printhead open lever.

Caution • Ensure that the printhead is fully open and engaged in the up position. If the printhead is not latched in the up position, it could fall on your hand during the procedure.

2.Locate the reflective sensor positioning lever.

3.Move the reflective sensor positioning lever across the width of the media until the reflective sensor aligns with the gap or notch. The glow of the red light assists in the proper placement of the reflective sensor.

4.Close the printhead assembly.

13163L Rev. 3 5/20/2004 Z4Mplus/Z6Mplus User Guide 85