Zebra Technologies Z6Mplus manual Exit Configuration Mode

Configuration

Overview

Exit Configuration Mode

You can leave configuration mode at any time.

To exit configuration mode, complete these steps:

1.From the front panel, press SETUP/EXIT. The SAVE CHANGES display appears.

2.Press PLUS (+) or MINUS (–) to scroll through the choices (Table 8):

		Table 8 • Save Options When Leaving Setup Mode
LCD Display		Description
PERMANENT		Permanently saves the changes. Values are stored in the printer even when power
		is turned off.
TEMPORARY		Saves the changes until you change them again or until power is turned off.
CANCEL		Cancels all changes from the time you pressed SETUP/EXIT except the
		darkness and tear-off settings (if they were changed).
LOAD	DEFAULTS	Sets all parameters other than the network settings back to the factory defaults.
		To see the factory default values, see Configuration and Calibration LCD
		Displays on page 57.
		Note • Loading factory defaults causes the printer to auto-calibrate.
LOAD	LAST SAVE	Loads values from the last permanent save.
DEFAULT NET		Sets the wired and wireless network settings back to factory defaults.

3.Press SELECT to select the displayed choice.

4.Press SETUP/EXIT to save your choice.

13163L Rev. 3 5/20/2004 Z4Mplus/Z6Mplus User Guide 51