LG Electronics 42LT670H, 55LS675H Teaching FTG Configuration to a TV, FTG Mode via CPU Cont

FTG Mode via CPU (Cont.)

Teaching FTG Configuration to a TV

This section describes how to “Teach” an FTG Configuration file from a USB memory device to a TV. Ensure you have completed the procedure on the previous page to create the FTG Configuration file before proceeding with the steps below.

Notes: • If the TV EBL is already in FTG Mode, you cannot use this procedure to make changes to the FTG Channel Map and FTG Installer Menu settings. You must use a direct PC-to-TV connection as described on page 44 or an FMA head end device to reconfigure the EBL.

•If the preceding condition applies, but you wish to switch the TV to FTG mode via CPU, refer to Reference section, “Restoring Factory Defaults on the TV(s),” for further information before proceeding.

•If the Automated Installation Routine Wizard appears on the screen when you turn ON the TV, you can use the “USB Configuration” option to configure this TV, if desired (see “USB Configuration” on page 13).

1.Turn ON the TV, and then plug the USB memory device that contains the FTG Configuration file into the Target LT670H or LS675H TV USB IN port.

2.Press MENU SETTINGS on the Installer Remote to display the TV setup menus (TV is in Pass-through Mode) or the Function Menu (TV is already in FTG Mode).

3.Use the arrow navigation keys to select/highlight either the Option menu icon from the TV setup menus or the Lock menu icon from the Function Menu. Then, press the number “7” key a total of seven times to display the USB Download Menu.

4.Use the Up/Down arrow keys to select Teach To TV (TLX), and then press OK.

5.Use the Up/Down arrow keys to select the FTG Configuration file you want to install, and then press OK.

Teaching status will be shown on a progress bar in a new window.

Do NOT remove the USB device until Teaching is complete. When the Teaching process is complete, the TV will briefly display a “Teaching Completed” window and then exit the USB Download Menu.

6.Remove the USB memory device from the Target TV, and verify that the FTG Configuration is resident on the Target TV.

The Target TV CPU is now in FTG Mode (if it was previously in Pass- through Mode).

Note: After the Teaching process is complete, the TV tunes according to the Start Channel setting in the Installer Menu. If a Start Channel is specified, the TV will tune to that channel; otherwise, the TV will tune to the lowest logical channel in the FTG Channel Map.

USB Download Menu

Upgrade TV Software

Upgrade PTC Software

Teach To TV (TLL)

Teach To TV (TLX)

Previous OK

Teach To TV (TLX)

xxLT670H-UA00005.TLX

Previous OK

Teach To TV

UPDATING...

50%

Do not unplug!

206-4213 41