LG Electronics 55LS675H, 42LT670H Custom Master TV Setup Cont, Custom Master TV Setup Procedure

Custom Master TV Setup (Cont.)

Custom Master TV Setup Procedure

1.Turn ON the TV.

If the Automated Installation Routine Wizard appears on the screen when you turn ON the TV, use the Up/Down arrow keys on the Installer Remote to select Exit from the Welcome screen, and press OK to exit the wizard.

2.Set Installer Menu items.

This step provides specific instruction only on the Installer Menu items that should be set on a Master TV. Refer to pages 18 to 26 for detailed information on all Installer Menu items.

a)Use the Installer Remote to access the PTC Installer Menu (see “Accessing the Installer Menu” on page 18 for further information).

The next step depends on whether the Automated Installation Routine Wizard appeared when you turned ON the TV:

•If the wizard did appear, the TV is in a factory default state, and you can proceed to set Installer Menu items. Go to step (c).

•If the wizard did not appear, go to step (b).

b)Set Installer Menu item 117 FACT DEFAULT to 001 and press OK on the Installer Remote. 

This clears all Installer Menu custom settings, channel lineup, etc. and restores the factory default settings. The value will change back to 0 after the PTC has been restored to factory default condition. This step ensures that the TV Channel Memory will be the active channel lineup. 

c)Set Installer Menu item 003 BAND/AFC, as appropriate.

• Broadcast: Set to 000. • HRC: Set to 002.

xxLT670H PTC INSTALLER MENU

CPU-CTV

000	INSTALLER SEQ	000
UPN	000-000-000-000	ASIC D279
PTC	V1.00.009	CPU V3.17.00

Typical Installer Menu

Note: The Installer Menu header will vary depending on the TV you are setting up.

117	FACT DEFAULT	000
003	BAND/AFC	001

Adjust the values for these

Installer Menu items, as required.

• CATV: Set to 001 (default). • IRC: Set to 003.

d)Set any other Installer Menu items that affect your TV programming network to the required configuration. For example, enable/disable Aux inputs, set a Start Channel, etc.

e)After you have adjusted all Installer Menu item settings as required, press OK once on the Installer Remote to save your changes; then, press OK again to exit the menu.

Note: If you performed step (b) above to restore factory defaults, the Automated Installation Routine Wizard will re-activate as soon as you exit the Installer Menu. Exit the wizard (see step 1), and then continue with step 3.

3.Set up TV features.

On-screen setup menus control the features of the TV. Press MENU SETTINGS on the Installer Remote to access the TV setup menus, and then set Channel, Picture, Audio, Lock, Time, etc. options to the desired configurations. See “Clonable TV Setup Menu Features” list on previous page and also notes on the following page.

PICTURE	AUDIO	CHANNEL	TIME
LOCK	OPTION	INPUT	MY MEDIA

Use the TV setup menus to set the TV features to the desired configuration for the end user.

(Continued on next page)

206-4213 15