FTG Mode via EBL
The following steps outline local FTG configuration of individual TV EBLs using a direct
Notes: • FTG Device Configuration Application software is available online at: www.LGsolutions.com/ ftgsoftware.
•If the TV CPU is already in FTG Mode, you cannot use this procedure to make changes to the FTG Channel Map and FTG Installer Menu settings. Instead, refer to and use the processes described on pages 39 to 43 to reconfigure the TV CPU.
•If the preceding condition applies, but you wish to switch the TV to FTG Mode via EBL, refer to Reference section, “Restoring Factory Defaults on the TV(s),” for further information before proceeding.
1. Install (if necessary) and launch the FTG Device |
Configuration Application (v5.0.0 or higher) on the |
LT670H Jack Panel
PC that will be used to configure the EBL. |
2. Build an FTG Channel Map using the FTG Channel |
Map Editor in the FTG Channel Map Configuration |
Utility (or, if applicable, open an existing FTG |
Configuration [.rml] file). |
Note: Up to 141 logical channels can be defined in |
the FTG Channel Map. |
3. Connect the PC to the |
TV’s rear jack panel using a |
cable |
device driver on the PC. |
AV IN
VIDEO |
|
L R |
| |
| Required for direct |
| TV FTG configuration. |
AUDIO IN |
|
(RGB/DVI) |
|
| ANTENNA/ |
| CABLE IN |
PTC SERVICE | Laptop |
(SERVICE ONLY) | PC |
| |
| |
CFG |
|
4. | Turn ON the TV. |
| Note: If Installer Menu item 118 POWER SAVINGS |
| is set to 3 (default), the TV must be ON in order for |
| steps 5 and 6 below to be successful. |
5. | “Write” the FTG Channel Map to the EBL (switches |
| the EBL from |
| Note: After a “Write” of new data, the TV will briefly |
| display a green text banner that shows the EBL |
| firmware version and release date. |
6. | “Read” the current FTG Installer Menu settings from |
| the EBL using the FTG Installer Menu Configuration |
| Utility. If necessary to make changes to Installer |
| Menu items, “Write” them back to the EBL in FTG |
| Mode. |
7. | Save the FTG Channel Map and FTG Installer |
| Menu settings to an FTG Configuration (.rml) file for |
| future use. |
8. | Tune the TV to a logical channel in the FTG |
| Channel Map. |
Use for direct
TV FTG configuration.
LS675H Jack Panel
|
|
| |
|
|
| Required for direct |
|
|
| TV FTG configuration. |
|
| AUDIO IN |
|
|
| (RGB/DVI) | ANTENNA/ |
| AV IN |
| |
|
| CABLE IN | |
| VIDEO | PTC SERVICE | Laptop |
L R | (SERVICE ONLY) | PC | |
| |||
|
|
|
Use for direct
TV FTG configuration.
44 |