Automated Installation Routine Wizard (Cont.)
USB Configuration
This section describes how to configure a TV for FTG Mode via CPU operation using an FTG Configuration (.tlx) file loaded on a USB memory device.
Note: Refer to the
Note: This procedure assumes that the FTG Configuration file contains an FTG Channel Map. If not, any Installer Menu and/or TV setup menu settings contained in the file will be transferred to the TV (as with typical cloning); however, the TV will remain in
1.Plug the USB memory device that contains the FTG Configuration (.tlx) file into the Target LT670H or LS675H TV USB IN port.
2.Use the Up/Down arrow keys on the Installer Remote
to select/highlight USB Configuration from the Automated Installation Routine Wizard Welcome screen. Then, press OK.
3.In the Accessing USB Storage Device window, use the Up/ Down arrow keys to select the FTG Configuration file you wish to use to configure this TV, and then press OK.
The TV will show configuration progress in a new window. Do NOT remove the USB device until configuration is complete. When the configuration is complete, the TV will briefly display a “Complete” window and then exit the Automated Installation Routine Wizard.
4.Remove the USB memory device, and verify that the FTG Configuration is resident on the Target TV.
The Target TV CPU is now in FTG Mode.
Note: After the configuration process is complete, the TV tunes according to the Start Channel setting in the Installer Menu. If a Start Channel is specified, the TV will tune to that channel; otherwise, the TV will tune to the lowest logical channel in the FTG Channel Map.
Accessing USB Storage Device | Move | OK | Prev. |
Please select configuration file (*.tlx)
USB Configuration
Configuring TV
Please wait... | 95% | ||
|
|
|
|
Warning - Do not remove the USB device during this process
13 |