LG Electronics 37LT670H, 55LS675H USB Cloning Procedures Cont, Teach Master TV Setup to Target TV

USB Cloning Procedures (Cont.)

Teach Master TV Setup to Target TV

1.Turn ON the Target TV.

The next step depends on whether the Automated Installation Routine Wizard appears on the screen when you turn ON the TV:

•If the wizard is displayed, the TV is already in the required factory default state. Use the Up/Down arrow keys on the Installer

Remote to select Exit from the Welcome screen, and press OK to exit the wizard. Then, go to step 3.

•Otherwise, ensure the Target TV is in Pass-through Mode. Then, continue with step 2.

2.Use the Installer Remote to access the Target TV Installer Menu (see “Accessing the Installer Menu” on page 18 for further information). Set Installer Menu item 117 FACT DEFAULT to 001, and press OK. When the value changes back to 0, press OK again to exit the Installer Menu.

Note: This step restores factory default settings on the TV, which will in turn re-activate the Automated Installation Routine Wizard. Use the Up/ Down arrow keys on the Installer Remote to select Exit from the Wel- come screen. Then, press OK to exit the wizard.

3.Tune/set the TV to an analog or digital channel or Aux input (ideally the same source tuned for 2-5-5 + MENU Mode during the Master TV Setup procedure).

4.Plug the USB memory device with the .tll file into the Target TV USB IN port.

5.Press MENU SETTINGS on the Installer Remote to display the TV setup menus. Use the arrow navigation keys to select/highlight the Option menu icon, and then press the number “7” key a total of seven times to display the USB Download Menu.

6.Use the Up/Down arrow keys to select Teach To TV (TLL), and then press OK.

7.Use the Up/Down arrow keys to select the Master TV Setup you want to install, and then press OK. Note: Filenames identify the TV and the TLL version (see example at right).

Teaching status will be shown on a progress bar in a new window. When the Teaching process is complete, the USB Download menu will reappear on the screen.

8.When Teaching is done, press on the Installer Remote to exit the USB Download Menu, remove the USB memory device from the Target TV, and turn OFF the TV.

9.After a few seconds, turn ON the TV, and verify that the Master TV Setup is now resident on the Target TV.

Note: When you turn it back ON, the TV will tune according to the setting of Installer Menu item 004 STRT CHANNEL (Start Channel). If a Start Channel is specified, the TV will tune to that channel; otherwise, the TV will return to the last channel tuned.

USB Download Menu

Upgrade TV Software

Upgrade PTC Software

Teach To TV (TLL)

Teach To TV (TLX)

Previous OK

Teach To TV (TLL)

xxLT670H-UA00001.TLL

Previous OK

Teach To TV

UPDATING...

50%

Do not remove the USB from the port!

Do not unplug!

32 206-4213