Zebra Technologies Z6Mplus manual No 1. Press Select, Continue with Select Media Type

Configuration

Basic Configuration

Adjust Tear-Off Position

The Tear-Off position defines the position of the label on the tear-off bar. When working with non-continuous labels, the inter-label gap should be on the tear bar. This setting does not apply to continuous media.

4.Are you using continuous media?

If...	Then...
Yes	1. Press PLUS (+) to move to the next option: PRINT MODE .

2.Continue with Select Print Mode.

No 1. Continue with Step 5.

5.Does the inter-label gap line up on the tear bar?

If...	Then...
Yes	1. Press PLUS (+) to move to the next option: PRINT MODE .

2.Continue with Select Print Mode.

No 1. Press SELECT.

2.Press PLUS (+) to move the label forward or MINUS (–) to move the label backward. Repeat this until the label lines up correctly.

3.Press SELECT to accept the changes.

4.Press PLUS (+) to move to the next option.

PRINT MODE displays. Continue with Select Print Mode.

Select Print Mode

When the wrong Print Mode is selected, the top of the label is not found by the printer. Examples of common problems include when the gaps between noncontinuous labels do not line up on the tear bar or when continuous media is not being cut at the right interval.

6.Do the labels line up or cut correctly?

If...	Then...
Yes	1.	Press PLUS (+) to move to the next option: MEDIA TYPE .
	2.	Continue with Select Media Type.
No	Review the media and the printer options, then complete the following steps:
	1.	Press SELECT.
	2.	Press PLUS (+) or MINUS (–) to scroll through the setting options. Stop
		at the setting that matches your printer options (Tear-Off, Peel-Off, Cutter,
		or Rewind).
	3.	Press SELECT to accept the change.
	4.	Press PLUS (+) to move to the next option.
		MEDIA TYPE displays. Continue with Select Media Type.

54 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004