Zebra Technologies Z6Mplus manual Feed and Pause Self Test, Communication Diagnostics Test

Troubleshooting

Printer Diagnostics

FEED and PAUSE Self Test

Performing this self test temporarily resets the printer configuration to the factory default values. These values are active only until power is turned off unless you save them permanently in memory.

To perform a FEED and PAUSE self test, complete these steps:

1.Turn Off (O) the printer.

2.Press and hold FEED and PAUSE while turning the power On (I). Hold FEED and PAUSE until the DATA light turns off.

No labels print at the end of this test.

Communication Diagnostics Test

This test is controlled from the front panel display (see Setting Communication Diagnostics Mode on page 66). A typical printout from this test is shown in Figure 43. Turn the printer Off (O) to exit this self test.

Note • This label prints upside-down.

Figure 43 • Communication Diagnostics Test Printout

13163L Rev. 3 5/20/2004 Z4Mplus/Z6Mplus User Guide 99