Zebra Technologies Z6Mplus manual Rewind/Peel-Off Mode

Printer Operation

Load Roll Media

Rewind/Peel-Off Mode

The Rewind option must be installed to use this mode. The option is shown in Figure 21.

Figure 21 • Rewind/Peel Mode

2 3

15 1

14

13				4
				5
12
11
10	9	8	7	6

1Printhead Assembly

2Transmissive Sensor

3Label Supply Guide

4Label Supply Hanger

5Rewind Spindle

6Rewind Label Guide

7Thumbscrew

8Dancer

9Label Guide

10Media Alignment Spindle

11Printhead Open Lever

12Peel Assembly

13Label

14Rewind Base Assembly

15Peel Lever

To load media in Rewind/Peel-Off Mode, complete these steps:

1.Press the printhead open lever. The printhead assembly springs up.

Caution • Ensure that the printhead is fully open and engaged in the upright position. If you fail to latch the printhead, it could fall on your hand during the procedure.

2.Flip down the media supply guide.

3.Slide the media guide as far from the main frame as possible.

13163L Rev. 3 5/20/2004 Z4Mplus/Z6Mplus User Guide 33