Panasonic KX-TCD961CXB Selecting the Stand-by Mode Display, Bell Selection, F3 i0, Iu2

KX-TCD961CXB(47~56) 99.12.3 2:20 PM Page 51

Selecting the Stand-by Mode Display

You can choose whether to display the currently connected base unit number, handset number or no display while in the stand-by mode. The factory preset is the base unit number.

1 Press .

2Press G or F until “F3 i ” is displayed, then press O K .

•The current setting is displayed.

1: Base unit number

2: Handset number 0: No display

F3 i0 i

3Press G or F to select the desired setting.

•You can also press 1 , 2 or 0 to select the setting.

4Press .

•A confirmation tone sounds and the display will return to the stand-by mode. Ex. Handset number is selected.

[ 2 ]

Bell Selection

There are three choices for bell selection. When a call is being received:

—all handsets ring. “All handsets”

—the selected handset(s) ring(s). “Specified handset(s)”

—the selected handset rings first, then if it does not answer, all other handsets will ring. “First handset” The factory preset is “All handsets”. To change the bell selection, program as follows.

Multi-Unit User

Selecting specified handset(s)

You can choose which handset(s) you want to ring.

1 Press then I N T . 2 Press 1 .

3Enter the base unit password (p. 29).

•The current setting is displayed. 1: All handsets

2: Specified handset(s)

3: First handset

Ex. All handsets is selected.

iu i

4 Press 2 .

•The current registered handset number(s) is/are displayed.

Ex. Handset 1, 2, 3, 4, 5 and 6 are registered.

iu2 - i23456

5Enter the handset number(s) you want to ring.

•The selected handset number(s) flash(es).

•If you misdial, press the number(s) again.

6Press .

•A confirmation tone sounds and the display will return to the stand-by mode.

Operations Chapter 5

51