Panasonic KX-TCD961CXB Registration, F7 i, Registering a Handset in the Base Unit

KX-TCD961CXB(47~56) 99.12.3 2:20 PM Page 48

Registration

Registering a Handset in the Base Unit

You must register the handset in the base unit before use.

•Charge the optional handset batteries for about 4 hours before initial use.

•Make sure that the power is ON (p. 13) and the unit is in the stand-by mode.

•Register the handset number within 1 minute. If not registered within 1 minute, press on the handset to cancel the programming mode. Then start again from step 1.

1Base unit where handset is to be

registered:

Press and hold on the base unit for more than 10 seconds until the in

use indicator ( ) lights and a confirmation tone sounds.

2Handset:

Press .

3Press G or F until “F7 i ” is displayed.

4Press O K .

•The available base unit numbers are displayed.

F7 i i234

5 Press the desired base unit number 1 to 4 .

•The number is assigned as the base unit number for the handset.

•While the handset is searching for the base unit, “- ” flashes across on the display.

6Enter the base unit password (p. 29).

F7 i - - - -

7 Press .

•A confirmation tone sounds and the display will return to the stand-by mode.

•The in use indicator ( ) on the base unit will go out.

•To register the handset in more than one base unit, repeat from step 1 with the other base unit(s).

•The base unit number which the handset is currently in contact with can be displayed in the stand-by mode (p. 51). Calls (both incoming and outgoing) can be conducted only via the displayed base unit (even if the radio areas overlap with neighbouring base units).

-

48