Panasonic KX-TCD961CXB Function item, Time p, To set the greeting monitor, Function p, Language p

KX-TCD961CXB(17~21) 99.12.3 2:06 PM Page 18

Preparing the Answering System

Programming Summary for the Answering System

You can program function items using the handset near the base unit. See the corresponding pages for function details.

Make sure that the power is ON (p. 13) and you are in the stand-by mode.

<Stand-by mode>

- i -

Press then I N T .

Press .

Enter a desired function command as shown below.

Command	Function item	Command	Function item
0	To adjust the time and day (p. 19)	3	To select the caller’s recording
			time (p. 20)
1	To set the remote code (p. 42)	4	To set the greeting monitor
			function (p. 21)
2	To select the number of rings	6	To select the voice guidance
	(p. 21)		language (p. 16)

•If “ ” flashes on the handset display and an alarm tone sounds, move closer to the base unit and try again.

•To cancel during programming, press . Start again from the beginning.

•To return to the previous step during programming, press C .

•When programming is completed, a confirmation tone sounds.*

•If 6 beeps sound on the base unit during programming, a wrong key was pressed. Enter the correct number.

*What the confirmation tone means

1 beep: The new programmed setting or selection is done.

2 beeps: The setting or selection is the same as the previous one.

6 beeps: The setting or selection is not correct. Try again from the beginning.

18