Configuration
Configuration and Calibration LCD Displays
| Table 10 • Print Server LCD Displays (Continued) |
|
|
LCD | Explanation |
|
|
AUTH . TYPE 2,3 | Authentication Type |
| Default: OPEN |
| Selections: OPEN, SHARED |
|
|
LEAP MODE 3,4 | An encryption method that is available with some wireless cards. Set the LEAP user |
| name and password through the printer web pages. |
| Accepted Values: ON, OFF |
| Default Value: OFF |
|
|
ENCRYPTION | Encryption Mode |
MODE 2,3 | Default: OFF |
| Selections: OFF, |
|
|
ENCRYPTION | Encryption Index |
INDEX 2,3 | Default: 1 |
| Selections: 1, 2, 3, 4 |
RESET NETWORK 1,3 Reset Network
This option resets the wireless card and the print server when the wireless option is running. Selecting this option has no effect when the wireless option is not running, when there is no card inserted, or when the wireless password is anything other than the default (zero).
1.Press the right oval to select YES .
The LCD prompts ARE YOU SURE? .
•Press the left oval to select NO to cancel the request.
•Press the right oval to select YES and reset the network.
1These parameters appear after the system recognizes the existence of a ZebraNet print server (wired or wireless). After the print server is recognized, all zeroes (000.000.000.000) will display until the printer obtains an IP address or defaults to address 192.168.254.254.
2Appears only when the ZebraNet Wireless Print Server is installed.
3If a wireless password is set, you must enter the wireless password (not the printer password) to access this parameter.
4This parameter appears 1) when no wireless card is inserted or 2) when the wireless card is associated to the WLAN and the card supports LEAP.
13163L Rev. 3 5/20/2004 | Z4Mplus/Z6Mplus User Guide | 73 |
