Zebra Technologies Z6Mplus manual Go to Configuration on

Printer Operation

Print a Configuration Label

4.Did the configuration label print correctly?

If the label...	Then...
Printed correctly	1.	Go to Configuration on page 49.
Did not print or is aligned 1.		Review the following items in the order shown. Do
improperly		only as many steps as needed to solve the printing
		problem.

•Review Types of Media on page 15 to make sure that you have the correct type of media for your application.

•Review Ribbon on page 17. If you are using direct thermal media, you do not need to use ribbon. If you are using thermal media, ribbon is required for printing.

•Review Load Roll Media on page 25 or Load Fanfold Media on page 38.

•Configure the printer according to the directions given in Basic Configuration on page 53.

•Check the position of the media sensor and move if necessary. Follow the directions in Position the Label Sensor on page 84.

44 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004