Zebra Technologies Z6Mplus Cutter Mode, To load media in Cutter-Off Mode, complete these steps

Printer Operation

Load Roll Media

8.Ensure the media is against the back of the transmissive sensor. Slide in the media guide until it touches, but does not restrict, the edge of the label.

9.Close the printhead assembly.

10.The printer is paused (the Pause light is on), press PAUSE to enable printing.

Cutter Mode

Cutter Mode requires that the cutter be installed. The option is shown in Figure 16.

Figure 16 • Cutter Mode

3

2

1

8

9

5

4

7 6

1Printhead Assembly

2Transmissive Sensor

3Label Supply Guide

4Label Supply Hanger

5Dancer

6Label Guide

7Printhead Open Lever

8Cutter Module

9Catch Tray

To load media in Cutter-Off Mode, complete these steps:

1.Press the printhead open lever. The printhead assembly springs up.

Caution • Ensure that the printhead is fully open and engaged in the upright position. If you fail to latch the printhead, it could fall on your hand during the procedure.

2.Flip down the media supply guide.

3.Slide out the media guide as far from the printer frame as possible.

4.Place the roll of media on the media supply hanger and orient the media properly.

5.Flip up the media supply guide.

26 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004