Zebra Technologies Z6Mplus manual ZPL Mode, Media, Head Close

Configuration

Configuration and Calibration LCD Displays

Table 9 • Printer Parameters and Other LCD Displays (Sheet 12 of 15)

Parameter Action/Explanation

ZPL MODE		Selecting ZPL Mode
		The printer remains in the selected mode until it is changed by this front panel
		instruction or by using a ZPL/ZPL II command. The printer accepts label formats
		written in either ZPL or ZPL II. This eliminates the need to rewrite any ZPL formats
		you already have. See the ZPL II Programming Guide Volume II for more information
		on the differences between ZPL and ZPL II.
		Default: ZPL II
		Selections: ZPL II, ZPL
		1.	Press SELECT to select the parameter.
		2.	Press PLUS (+) or MINUS (–) to display other choices.
		3.	Press SELECT to accept any changes and deselect the parameter.
MEDIA	POWER	UP Media Power Up
		Establishes the action of the media when the printer is turned on.
		Default: CALIBRATION
		Selections:
		• CALIBRATION: Recalibrates the media and ribbon sensors.
		• LENGTH: Determines the length of the label.
		• NO MOTION: Media does not move.
		• FEED: Feeds the label to the first web.
		1.	Press SELECT to select the parameter.
		2.	Press PLUS (+) or MINUS (–) to display other choices.
		3.	Press SELECT to accept any changes and deselect the parameter.
HEAD	CLOSE	Head Close
		Determines the action of the media after the printhead has been opened and then closed.
		Default: Calibration
		Selections:
		• CALIBRATION: Recalibrates the media and ribbon sensors.
		• LENGTH: Determines the length of the label.
		• NO MOTION: Media does not move.
		• FEED: Feeds the label to the first web.
		1.	Press SELECT to select the parameter.
		2.	Press PLUS (+) or MINUS (–) to display other choices.
		3.	Press SELECT to accept any changes and deselect the parameter.

68 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004