Zebra Technologies Z6Mplus manual List Fonts, List Images, List Formats, List Setup

Configuration

Configuration and Calibration LCD Displays

Table 9 • Printer Parameters and Other LCD Displays (Sheet 4 of 15)

Parameter Action/Explanation

MAXIMUM LENGTH Setting Maximum Length

Always set the value to at least 1 in. (25.4 mm) longer than the longest label to be used in the printer.

		Default: 39 in. (991 mm) for non-continuous material
		1.	Press SELECT to select the parameter.
		2.	Press PLUS (+) to increase the value
		3.	Press MINUS (–) to decrease the value.
		4.	Press SELECT to accept any changes and deselect the parameter.
LIST	FONTS	List Fonts
		This selection is used to print a label that lists all of the fonts currently available in the
		printer, including standard printer fonts plus any optional fonts. Fonts may be stored in
		RAM, FLASH memory, font EPROMs, or font cards.
		1.	Press SELECT to select the parameter.
		2.	Press PLUS (+) to print a label listing all of the available fonts.
		3.	Press SELECT to deselect the parameter.
LIST	BAR CODES	List Bar Codes
		This selection is used to print a label that lists all of the bar codes currently available in
		the printer.
		1.	Press SELECT to select the parameter.
		2.	Press PLUS (+) to print a label listing all of the available bar codes.
		3.	Press SELECT to deselect the parameter.
LIST	IMAGES	List Images
		This selection is used to print a label that lists all of the images currently stored in the
		printer’s RAM, FLASH memory, optional EPROM, or optional memory card.
		1.	Press SELECT to select the parameter.
		2.	Press PLUS (+) to print a label listing all of the available images.
		3.	Press SELECT to deselect the parameter.
LIST	FORMATS	List Formats
		This selection is used to print a label that lists all of the formats currently stored in the
		printer’s RAM, FLASH memory, optional EPROM, or optional memory card.
		1.	Press SELECT to select the parameter.
		2.	Press PLUS (+) to print a label listing all of the available formats.
		3.	Press SELECT to deselect the parameter.
LIST	SETUP	List Setup
		This selection is used to print a configuration label, which lists the current printer
		configuration information. (Same label as Figure 40 on page 96.)
		1.	Press SELECT to select the parameter.
		2.	Press PLUS (+) to print a configuration label.
		3.	Press SELECT to deselect the parameter.

60 Z4Mplus/Z6Mplus User Guide 13163L Rev. 3 5/20/2004