Zebra Technologies Z6Mplus manual Print a Configuration Label

Printer Operation

Print a Configuration Label

Print a Configuration Label

Print a configuration label to test the printer setup. Do this when the printer is first installed, or when the printer cannot properly detect the top of the label.

To print a configuration label, complete these steps:

1.Turn the printer power Off (O).

2.Press and hold CANCEL while turning the printer On (l). See Figure 3, Front Panel Controls and LEDs, on page 3.

3.Release CANCEL after the DATA light turns off (approximately five seconds).

A configuration label prints showing the printer’s currently stored parameters (similar to the labels shown in Figure 28).

Figure 28 • Sample Configuration Labels

Z6Mplus - 300 dpi Z4Mplus - 200dpi

4

4

13163L Rev. 3 5/20/2004 Z4Mplus/Z6Mplus User Guide 43