HP 20-Feb manual Configuring the Remote Management Card

Configuring the Remote Management Card

The library only requires one remote management card, which will already be installed when the library arrives.

Note	The library administrator password is required for this process. If
	the password is not set, you can view information but will not be
	permitted to configure your remote management card from your
	web browser. (See Enabling and Changing the Password on
	page 92.)

1.Connect to the network port of the card using a category 5 ethernet cable. Ensure that the cable is also connected to an active network port.

2.On the library’s back panel, verify that the link LED on the remote management card is green. If the LED is not green, a link has not been established with the local network. Ensure the network port is active by checking with your system administrator. (See Table 20 on page 133 for a description of the LEDs.)

3.Enter the Network Access menu.

Main Menu -> Administration -> Change Configuration -> Network

Access

4.If you would like to use DHCP/BOOTP to configure your remote management card, select [Yes]. (See Dynamic Host Configuration Protocol (DHCP) on page 97 or BOOTP on page 98.)

—A message will display to confirm your configuration through DHCP/ BOOTP, or alert you if DHCP/BOOTP failed.

—If successful, note the IP address, and skip to step 9.

—If DHCP/BOOTP was not successful, or if you do not want to use DHCP/BOOTP, contact your system administrator to obtain an IP address, subnet mask, and gateway address. Continue with step 5.

Chapter 3

Chapter 3 Configuring the Library 99