HP 20-Feb manual Sun Solaris, HP-UX and MPE/iX

Sun Solaris

For Sun Solaris™ operating systems, perform the following operating system configurations:

■Install the appropriate host bus adapter(s)

■Install the corresponding drivers for the interface card(s)

■To verify the hardware installation, look for the library and drives after powering up the host.

—Close all open applications and exit the Common Desktop Environment (CDE).

—Type “init 0” at any prompt. This will shut down all processes, and take you to the OpenBoot PROM.

—Type “reset”.

—At the OK prompt, type “probe-scsi-all”.

■Install the backup software

■Run a test backup to ensure that all components are properly configured.

HP-UX and MPE/iX

For more information on configuring these operating systems and verifying the connection, see the online configuration and diagnostic guide at http:// www.hp.com/go/support. Select your product and then select [manuals].

52 Verifying the Host Configuration Chapter 1