HP 20-Feb manual Removing the Library Cover and Feet 2/20 & 4/40 Series Only, Removing the Cover

Removing the Library Cover and Feet (2/20 & 4/40 Series Only)

To install a stand-alone library in a rack, remove the cover and feet by following these steps:

1.Remove the following six screws (Figure 57):

a.Four screws, one located at each of the four feet

b.Two screws near the bottom of the library and in the back

2.Lift the cover off the library.

	Note	The cover may fit tightly. If you cannot remove it easily, ease the
		sides out while lifting up on the cover.
Figure 57	Removing the Cover

172 Removing the Library Cover and Feet (2/20 & 4/40 Series Only) Chapter 5