Upgrading Firmware

Caution Before upgrading firmware, be sure to generate a support ticket using HP Library & Tape Tools (see page 154). The resulting information may be helpful to your service representative in resolving potential issues that may have prompted the firmware upgrade.

This section details the processes for upgrading library and drive firmware. Some of the processes used for upgrading library firmware are different from those used to upgrade drive firmware.

Firmware can be downloaded by:

Using HP Library & Tape Tools (library and drive firmware)

Using the remote management card (library and LTO drive firmware)

Using a firmware upgrade tape (drive firmware only)

Note

After upgrading firmware, library configuration settings will

 

revert back to the factory defaults, which could affect remote

 

management. For a complete list of factory defaults, see Table

 

12 on page 91.

 

 

Checking the Firmware Revision

Before downloading new firmware, check your current firmware revisions, and compare them to the latest available revisions at http://www.hp.com/go/ support.

Note

If the library is in a partial availability state due to a firmware

 

mismatch, new firmware must be downloaded to resolve the

 

condition. (See Partial Availability State on page 120.)

 

 

1. Use the following menu from the front panel:

Main Menu -> Information -> Firmware Revisions

176 Upgrading Firmware

Chapter 5

Page 178
Image 178
HP 20-Feb manual Upgrading Firmware, Checking the Firmware Revision, Mismatch, new firmware must be downloaded to resolve