HP 20-Feb manual Connecting and Powering on the Library

7.For 8/80 and 10/100 Series Libraries:

Connect the power cords on the rack to a power outlet on each library level.

For 2/20, 4/40, and 6/60 series libraries, skip to the next step.

8.Connect the power cord(s) from the library to a grounded power receptacle, and power on the library. The power (standby) switch is recessed and on the lowest level of the library.

After the power-up test is complete (after several minutes), you will see the Home Screen on the library’s front panel. The Home Screen displays the status of the drives and library.

9.From the front panel, configure the library for Fibre Channel. See Configuring the Library for Fibre Channel on page 102 for more information.

10.Connect a category 5 ethernet cable from the remote management card to an active network port (see Using the Remote Management Card on page 96).

11.Power on the host.

44 Connecting and Powering on the Library Chapter 1