HP 20-Feb manual Enabling and Changing the Password, Card

Enabling and Changing the Password

Note	Administration procedures can be password protected. These
	procedures include: diagnostic tests, configurations, online drive
	repair, and setting the date and time. A password is also
	required for administration through the remote management
	card.

Main Menu -> Administration -> Change Configuration -> Password

When the library is first installed, the password is inactive. To protect the system from unauthorized access, use the following procedure to set a password.

1.Enter the Password menu. A status screen will indicate if a password is enabled.

—If the password is turned off, select Set New Password to enable the password.

—If the password is turned on, select Change Password to enter the new password. It must be exactly eight digits.

—If the password is turned on, select Turn Password Off to clear the password.

Note	If you enter more than eight digits, the ninth digit will become
	the first digit of the new password.

2. Select [OK] to exit.

Caution Be sure to document the password. If you forget the password, contact your service representative.

92 Configuring the Library Chapter 3