HP 20-Feb manual Actual connection achieved depends on the external

7.Press [OK] when complete to save the changes, or select [QUIT] to return to the beginning of the fibre configuration menu. If you select [QUIT], a message will display indicating the old values will be retained.

If you select [OK], a message will display indicating that the settings are being stored onto the Fibre Channel controller. If this is successful, a message displays indicating that the new settings will be attempted at the next restart.

8.To immediately apply the new settings, select [RESTART], or select [DONE] to wait until the next power cycle.

When the Fibre Channel controller is restarted, or when the library is power-cycled,FUTURE SETTINGS are copied into CURRENT SETTINGS. The Fibre Channel controller always attempts to connect using CURRENT SETTINGS.

If you select [RESTART], the Fibre Channel controller is restarted. This should not be attempted if data transfers or library operations are in progress. The [RESTART] operation normally completes within 90 seconds. The display will report the status of the operation when it is complete.

Note	The actual connection achieved depends on the external
	topology and network. Consequently, CURRENT STATUS may
	differ from CURRENT SETTINGS.
Note	You can also change configuration from remote access. See
	Using the Remote Management Card on page 96.

104 Configuring the Library for Fibre Channel Chapter 3