HP 20-Feb Drivers pull-down menu, Library administrator password is required for this process

Note The firmware download may take several minutes to complete.

Using the Remote Management Card (library and LTO drive firmware)

All library components, except drives, can be easily downloaded from the remote management card.

Note	The firmware file is available from HP Support at http://
	www.hp.com/go/support. These files must be loaded onto the
	local host computer before downloading firmware. First select
	your product, and then make a selection from the Downloads &
	Drivers pull-down menu.

1.Once the library is configured for network access, enter the IP address within your web browser to launch the Web-Based Library Administrator pages. (See Using the Remote Management Card on page 96.)

Note	The library administrator password is required for this process
	and is not set by default. If the password is not set, you will not
	be permitted to download firmware.

2.Select the [Configuration] tab from the main screen.

3.Select the [Firmware Download] button.

4.Enter the full pathname for the download file, or use the [Browse] button to locate the file.

5.Select the [Start Firmware Download] button to begin the actual process of downloading the library firmware.

Once the download process begins, the progress and status of the download will display on the lower half of your screen.

Note The firmware download may take several minutes to complete.

178 Upgrading Firmware Chapter 5