HP 20-Feb manual Removing and Replacing Cards, Removing a Card

Removing and Replacing Cards

Caution This library contains very sensitive electrical components. It is important to follow the proper procedures to prevent electrostatic discharge (ESD). Use wrist-grounding straps and anti-static mats when removing and replacing cards and major assemblies.

Failure to follow proper procedures could lead to intermittent failures or premature hard failures.

Caution The Fibre Channel printed circuit boards may contain a laser system (GBIC or GLM module) that is classified as a “Class-I Laser Product” under a U.S. Department of Health and Human Services (DHHS) Radiation Performance standard according to the Radiation Control for Health and Safety Act of 1968 and EN60825-1(+A11) safety of laser products. The compliance statement is located on the module.

Before powering the library off to remove a card, review the LEDs on the back of each card to ensure there is no activity (see Interpreting Library LEDs on page 130).

Removing a Card

1.Note the library configuration settings (if you will be downloading new firmware), and power off the library.

2.Note how the library is connected and the placement of the card, and then remove all external cables attached to the card.

3.Loosen the two thumbscrews on the card by hand or with a screwdriver.

4.Remove the card by gently pulling it outward.

160 Removing and Replacing Cards Chapter 5