HP 20-Feb manual Chapter

8. Extend the rack’s anti-tip foot.

WARNING Failure to extend the anti-tip foot could result in personal injury or damage to the library.

9.Open the magazine drawers and loosen the screws that lock the library into place (Figure 14 on page 30). The screws are located in front of the trim brackets.

10.Remove the stop bracket. (See Figure 9 on page 25 and Figure 10 on page 26.)

11.Push the library out of the rack until it hits the latch stops (approximately 2/3 of the library is out of the rack).

12.Reattach the lifting straps to the sides of the library.

13.Release the library from the rack. 4/40 and 6/60 Series Libraries:

Depress the latch stops at the top of the library with a screwdriver or similar tool (Figure 26 on page 58).

2/20 Series Libraries:

If the library does not have enough clearance above for a tool to be inserted, unscrew the four screws (two on each side) from the top (black) mounting rail on the front of the library. Pull the library partially out, then lower the front half of the library to ease it under the latch stops.

WARNING Once you have loosened the mounting screws, the library is no longer secured inside the rack and can cause bodily harm and/ or damage to the library if it is dropped.

Chapter 1

Chapter 1 Moving or Shipping the Library 57