HP 20-Feb manual Enter the IP Address Use the + key to change the number, Hand corner of any

Note The MAC address is unique to each remote management card and is used for identification. This address cannot be configured. To successfully use BOOTP from the library, your system administrator must first configure the BOOTP server using the MAC address. (See BOOTP on page 98.)

5.Enter the IP Address.

Use the [+] key to change the number.

Use the [->]key to move to the next number. Use the [Down] key to move to the next address.

6.Enter the subnet mask using the same procedure.

7.Enter the gateway address.

8.Press [OK] when complete to save the changes, or press [Quit] to exit the menu and not save the changes. A message will display to confirm the changes you have entered or alert you if the changes have not been saved.

9.Enter the designated IP address into the web browser to launch the Web- Based Library Administrator pages.

Example 1 - All modes (Manual, DHCP, or BOOTP): IP address = 15.28.33.12

http://15.28.33.12

Example 2 - Manual and BOOTP only: Device name = library1 http://library1

Note	To use a device name, your system administrator must add the
	device name you select to the domain name server (DNS).
Note	Instructions and online help screens describing remote
	management are available from the Web-Based Library
	Administrator pages by selecting the [?] button in the top right-
	hand corner of any page.

100 Configuring the Library Chapter 3